Summary: System can see new hard drive

From: <jsauer_at_dticam.dtic.mil>
Date: Fri Sep 14 2001 - 15:03:37 EDT
Thanks to Steve Wills and Matt Morris for responding.

Steve pegged it right with the suggestion of  a bad drive.
I installed a second disk in the same slot and
probe-scsi-all identified it correctly and devfsadm 
allowed it to be recognized by the format command.

Thanks again.
Jim

>  -----Original Message-----
> From: 	Jim Sauer [mailto:jsauer@dticam.dtic.mil] 
> Sent:	Monday, September 10, 2001 1:51 PM
> To:	Sun Managers (E-mail)
> Subject:	System can see new hard drive
> 
> System:  Ultra 1 running Solaris 8 with a MultiDisk.
> 
> I have four disks (Seagate ST32371WC) in slots
> 2,3,4, and 5 of the MultiDisk.  I've just added
> an additional identical type disk in the next slot
> (labeled slot 8 - there is no slot 6 or 7 in the Multidisk,
> but slot 2 thru 5, 8 thru 15)
> 
> 
> probe-scsi-all displays the following:
> 
> /sbus@1f,0/QLGC,is@1, 10000
> 
> /sbus@1f,0SUNW, fas@0,8800000
> 
> Target 2
> Unit 0 	Disk 	Seagate ST34371W
> 		Sun 4.2G
> 
> (Repeat for Target 3 thru 5)
> 
> Target 8    	(does not display "disk"  or "Seagate")
>  		  *** This is the new disk ***
> 
> unexpected message in 3
>                
> ** probe-scsi-all goes on to display the 2 internal drives
>    in the Ultra 1 and the internal tape drive and the external CD-ROM ***
> 
> Upon system boot, the system displays:
> 
>   Warning:   Connected command timeout for Target 0.0
>   Warning:   SCSI Bus MESSAGE OUT phase parity error
> 
> 
> This then goes on to corrupt /tmp and boots up in OpenWin vice CDE
> After manually fsck'ing /tmp, a reboot allows sysem to boot up properly in
> CDE.
> 
> The new disk does not show up when issuing the format command.
> 
> I've run "devfsadm" and "drvconfig"
> 
> 
> Any ideas on how to get this drive to "talk" correctly.
> 
> Thanks,
> Jim 
> 
> 
Received on Fri Sep 14 20:03:37 2001

This archive was generated by hypermail 2.1.8 : Wed Mar 23 2016 - 16:32:30 EDT