SUMMARY: In SE3510FC - unfail command fails to take failed controller online

From: Alejandro Guajardo <alex_at_itesm.mx>
Date: Tue Oct 24 2006 - 12:50:05 EDT
I have a SE3510 FC with dual controllers configured active-active with
4.15 FW:

sccli> show redundancy   
 Primary controller serial number: 8101936
 Primary controller location: Lower
 Redundancy mode: Active-Active
 Redundancy status: Enabled
 Secondary controller serial number: 8101885

I issued a "fail" command to verify failover and transparent access to
LUNs from hosts:

sccli> fail primary
Are you sure? y

After that, I have this:

sccli> show redundancy
 Primary controller serial number: 8101885
 Primary controller location: Upper
 Redundancy mode: Active-Active
 Redundancy status: Scanning
 Secondary controller serial number: 0

Everything worked just fine an the LUNs failed-over correctly. The
problem is that I can't make the failed controller go back online. I
tried:

1st option.-
sccli> unfail
Are you sure? y

sccli> show redundancy
 Primary controller serial number: 8101885
 Primary controller location: Upper
 Redundancy mode: Active-Active
 Redundancy status: Scanning
 Secondary controller serial number: 0

2nd option.-

sccli> reset controller
WARNING: This is a potentially dangerous operation.
The controller will go offline for several minutes.
Data loss may occur if the controller is currently in use.
Are you sure? y
sccli: shutting down controller...
sccli: controller is shut down
sccli: resetting controller...
sccli: controller has been reset

sccli> show redundancy
 Primary controller serial number: 8101885
 Primary controller location: Upper
 Redundancy mode: Active-Active
 Redundancy status: Scanning
 Secondary controller serial number: 0

---------------------------------------------------------------------------------
3rd and FINAL OPTION... THE ONE THAT WORKED...

--->>>>POWER CYCLE THE ARRAY.

After the power cycle, I got the previous active-active configuration
with failover on:
sccli> show redundancy   
 Primary controller serial number: 8101936
 Primary controller location: Lower
 Redundancy mode: Active-Active
 Redundancy status: Enabled
 Secondary controller serial number: 8101885

Thanks to Luis Croker for his response and help.

Regards,
Alex
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
Received on Tue Oct 24 12:52:46 2006

This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:44:02 EST