Many thanks to those who give advices: Juergen Waiblinger Dominic Clarke Luc I. Suryo Frangois Legal I retain explanation from Juergen Waiblinger > Hello, > > i have seen the same things (with external cdrom and dat) using the wrong > cables. You need a hd68 to hd50 cable which has termination inside. They > are a little bit more expensive but than it should work. Keeep in mind, > that you have 8 wires not used. If you have the possibility to check the > thing with a windows box you will see that the dat is working as the > lowlevel scsi driver from MS won't recognize the problem (but runs in > problems when you put data on the tape) > If you nare using a correct cable i would assume the DAT to be faulty. > btw. as far as i know in France you can get that from transtec > (www.transtec.fr) it's called CB-WT2SCSI-1. But I will not try this solution because I had success with another solution: I extracted the DAT from his box and installed it inside the SUN. Internals SCSI connectors was the same and it seems to work smoothly. On Mardi 15 Avril 2003 15:42, Philippe Bourdeu d'Aguerre wrote: > Hello, > > I try to install an external DAT on a SUN Blade 2000. It's a SEAGATE > STD124000N, DAT DDS3 with SCSI 2 interface. I connect it through a > HD68-HD50 cable but it doesn't work: > - active terminator doesn't light on > - on "boot -r" I get error messages: > Apr 14 10:44:35 limoux scsi: [ID 107833 kern.warning] WARNING: > /pci@8,700000/scsi@6,1 (glm1): Apr 14 10:44:35 limoux Connected command > timeout for Target 0.0 > Apr 14 10:44:35 limoux genunix: [ID 408822 kern.info] NOTICE: glm1: fault > detected in device; service still available Apr 14 10:44:35 limoux genunix: > [ID 611667 kern.info] NOTICE: glm1: Connected command timeout for Target > 0.0 Apr 14 10:44:35 limoux glm: [ID 280919 kern.warning] WARNING: > ID[SUNWpd.glm.cmd_timeout.6017] Apr 14 10:44:35 limoux scsi: [ID 107833 > kern.warning] WARNING: /pci@8,700000/scsi@6,1 (glm1): Apr 14 10:44:35 > limoux timeout on bus reset interrupt > Apr 14 10:44:35 limoux genunix: [ID 408789 kern.warning] WARNING: glm1: > fault detected in device; service unavailable Apr 14 10:44:35 limoux > genunix: [ID 451854 kern.warning] WARNING: glm1: timeout on bus reset > interrupt > > - devices are not created > > Can somebody confirms that SunBlade 2000 supports SCSI 2 devices ? Is there > any necessary conf ? > > Thanks. -- Philippe BOURDEU d'AGUERRE AIME - Campus de l'INSA http://www.aime.insa-tlse.fr/ 135, av. de Rangueil Tel +33 561 559 885 31077 TOULOUSE Cedex 4 - FRANCE Fax +33 561 559 873 _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagersReceived on Wed Apr 16 08:07:35 2003
This archive was generated by hypermail 2.1.8 : Thu Mar 03 2016 - 06:43:09 EST